Simpson Strong-Tie BVLZ-KT4 - ZMAX Galvanized Brick Veneer Ledger Connector 4ct

The BVLZ brick veneer ledger connector offers a new, code-compliant, and tested solution for securely adding a deck to an existing house with a brick veneer exterior. This innovative connector attaches a wood ledger to the house framing through the brick veneer, providing a viable alternative to constructing a free-standing deck. It installs without the need to remove or replace large sections of brick veneer, making it both practical and efficient.

Features:

• Code-Compliant: Provides a tested and approved method for attaching a deck ledger to a house with a brick veneer.
• Easy Installation: Allows drilling through mortar joints and minimizes penetrations through existing exterior water barriers.
• Versatile: Accommodates a wide range of air gaps and brick sizes.
• Inspection-Friendly: Enables inspection and approval by building departments in retrofit construction applications.
• Kit: Available as a four-part kit (BVLZ-KT4).

Material:

• 12 Gauge Steel
• Finish: ZMAX® Coating for enhanced corrosion resistance.

Installation:

1. Preparation: Use all specified fasteners supplied with the connector. Complete installation instructions are provided with each kit.
2. Positioning: Measure where each ledger plate will be positioned on the veneer. Align the center hole of the installation guide with the mortar joint in the brick veneer.
3. Drilling: Drill through the center hole using a hammer drill and a 1 1/8" masonry drill bit. Drill two 40º upward-angled holes using the guide and 1 1/8" diameter drill bit. Repeat for each plate location.
4. Marking: Mark the placement of each plate on the ledger board. Using the installation guide, drill a 1 1/8" diameter hole horizontally through the center hole and mark the two angled-hole locations. Then drill two 1 1/8" diameter angled holes at each marked location on the ledger.
5. Installation: Thread the compression strut into the back of the ledger plate to the end of the threads. Install the left-most and right-most plates on the ledger and attach each with six Strong-Drive SD Connector screws (provided).
6. Attaching to Veneer: Place the ledger board against the brick veneer and install two 14" Strong-Drive SDWH Timber-Hex HDG screws in each of the plates. Push downward on the drill while driving to ensure the screws are snug against the gusset channel and maintain a 40° angle while screwing into the rim joist.
7. Securing: Rotate compression struts with pliers until they bear tightly against the framing. Install the remaining BVLZ connectors along the length of the ledger.

The BVLZ brick veneer ledger connector ensures a strong, secure connection for your deck, while maintaining the integrity of the existing brick veneer exterior.